V.

Transmission of Television Signals

The audio and video signals of a television program are broadcast through the air by a transmitter. The transmitter superimposes the information in the camera's electronic signals onto carrier waves. The transmitter amplifies the carrier waves, making them much stronger, and sends them to a transmitting antenna. This transmitting antenna radiates the carrier waves in all directions, and the waves travel through the air to antennas connected to television sets or relay stations.

A.

The Transmitter

The transmitter superimposes the information from the electronic television signal onto carrier waves by modulating (varying) either the wave's amplitude, which corresponds to the wave's strength, or the wave's frequency, which corresponds to the number of times the wave oscillates each second (see Radio: Modulation). The amplitude of one carrier wave is modulated to carry the video signal (amplitude modulation, or AM) and the frequency of another wave is modulated to carry the audio signal (frequency modulation, or FM). These waves are combined to produce a carrier wave that contains both the video and audio information. The transmitter first generates and modulates the wave at a low power of several watts. After modulation, the transmitter amplifies the carrier signal to the desired power level, sometimes many kilowatts (1 kilowatt equals 1,000 watts), depending on how far the signal needs to travel, and then sends the carrier wave to the transmitting antenna.

The frequency of carrier waves is measured in hertz (Hz), which is equal to the number of wave peaks that pass by a point every second. The frequency of the modulated carrier wave varies, covering a range, or band, of about 4 million hertz, or 4 megahertz (4 MHz). This band is much wider than the band needed for radio broadcasting, which is about 10,000 Hz, or 10 kilohertz (10 kHz). Television stations that broadcast in the same area send out carrier waves on different bands of frequencies, each called a channel, so that the signals from different stations do not mix. To accommodate all the channels, which are spaced at least 6 MHz apart, television carrier frequencies are very high. Six MHz does not represent a significant chunk of bandwidth if the television stations broadcast between 50 and 800 MHz.

In the United States and Canada, there are two ranges of frequency bands that cover 67 different channels. The first range is called very high frequency (VHF), and it includes frequencies from 54 to 72 MHz, from 76 to 88 MHz, and from 174 to 216 MHz. These frequencies correspond to channels 2 through 13 on a television set. The second range, ultrahigh frequency (UHF), includes frequencies from 407 MHz to 806 MHz, and it corresponds to channels 14 through 69. However, channel 37 is used for radio astronomy and medical telemetry equipment, not for television broadcasting (see Radio and Television Broadcasting). When the transition to all-digital television broadcasting is complete, channels 52 through 69 will no longer be used for television signals. These frequencies may become available for other uses such as wireless communication.

The high-frequency waves radiated by transmitting antennas can travel only in a straight line, and may be blocked by obstacles in between the transmitting and receiving antennas. For this reason, transmitting antennas must be placed on tall buildings or towers. In practice, these transmitters have a range of about 120 km (75 mi). In addition to being blocked, some television signals may reflect off buildings or hills and reach a receiving antenna a little later than the signals that travel directly to the antenna. The result is a ghost, or second image, that appears on the television screen. Digital transmission, however, eliminates ghosts and snow since the picture that results is recreated from a digital code, not from analog waves. Television signals may also be sent clearly from almost any point on Earth to any other—and from spacecraft to Earth—by means of cables, microwave relay stations, and communications satellites.

B.

Cable Transmission

Cable television was first developed in the late 1940s to serve shadow areas—that is, areas that are blocked from receiving signals from a station's transmitting antenna. In these areas, a community antenna receives the signal, and the signal is then redistributed to the shadow areas by coaxial cable (a large cable with a wire core that can transmit the wide band of frequencies required for television) or, more recently, by fiber-optic cable. Viewers in most areas can now subscribe to a cable television service, which provides a wide variety of television programs and films adapted for television that are transmitted by cable directly to the viewer's television set. Digital data-compression techniques, which convert television signals to digital code in an efficient way, have increased cable's capacity to 500 or more channels.

C.

Microwave Relay Transmission

Microwave relay stations are tall towers that receive television signals, amplify them, and retransmit them as a microwave signal to the next relay station. Microwaves are electromagnetic waves that are much shorter than normal television carrier waves and can travel farther. The stations are placed about 50 km (30 mi) apart. Television networks once relied on relay stations to broadcast to affiliate stations located in cities far from the original source of the broadcast. The affiliate stations received the microwave transmission and rebroadcast it as a normal television signal to the local area. This system has now been replaced almost entirely by satellite transmission in which networks send or uplink their program signals to a satellite that in turn downlinks the signals to affiliate stations.

D.

Satellite Transmission

Communications satellites receive television signals from a ground station, amplify them, and relay them back to the earth over an antenna that covers a specified terrestrial area. The satellites circle the earth in a geosynchronous orbit, which means they stay above the same place on the earth at all times. Instead of a normal aerial antenna, receiving dishes are used to receive the signal and deliver it to the television set or station. The dishes can be fairly small for home use, or large and powerful, such as those used by cable and network television stations.

Satellite transmissions are used to efficiently distribute television and radio programs from one geographic location to another by networks; cable companies; individual broadcasters; program providers; and industrial, educational, and other organizations. Programs intended for specific subscribers are scrambled so that only the intended recipients, with appropriate decoders, can receive the program.

Direct-broadcast satellites (DBS) are used worldwide to deliver TV programming directly to TV receivers through small home dishes. The Federal Communications Commission (FCC) licensed several firms in the 1980s to begin DBS service in the United States. The actual launch of DBS satellites, however, was delayed due to the economic factors involved in developing a digital video compression system. The arrival in the early 1990s of digital compression made it possible for a single DBS satellite to carry more than 200 TV channels. DBS systems in North America are operating in the K_u band (12.0-19.0 GHz). DBS home systems consist of the receiving dish antenna and a low-noise amplifier that boosts the antenna signal level and feeds it to a coaxial cable. A receiving box converts the superhigh frequency (SHF) signals to lower frequencies and puts them on channels that the home TV set can display.